Drug test chain of custody form: the Federal CCF, non-DOT forms and what employers fill in (2026)
On this page
- What is the Federal Custody and Control Form?
- Which version of the CCF is current?
- What does the employer fill in?
- What do the collector, donor, laboratory and MRO fill in?
- Which CCF mistakes cancel a test?
- What chain of custody form do non-DOT tests use?
- Checklist for ordering a test
- Questions people ask
Every DOT-regulated drug test must be documented on the Federal Drug Testing Custody and Control Form (CCF), a five-part form approved by the Office of Management and Budget (OMB number 0930-0158); the current 2026 version was approved for use as of April 27, 2026, and laboratories may keep accepting the 2020 and 2023 versions until May 31, 2027. The employer's part is Step 1: the employer's and the Medical Review Officer's (MRO) contact details, the DOT agency, the reason for the test, whether it is observed, the specimen type and the employee's name and ID number, usually preprinted. Company (non-DOT) tests must not use the federal form; they use the laboratory's non-federal custody form, and some states set chain-of-custody rules for them, as of November 2026.
This page explains the form itself. How long each step takes after the form is signed is in how long pre-employment drug test results take, and the DOT program as a whole in DOT drug testing requirements.
Not legal advice. This page summarizes 49 CFR Part 40 on eCFR (up to date as of November 12, 2026), SAMHSA's 2026 CCF guidance and instructions, and the state statutes linked below, checked as of November 2026. Your laboratory or third-party administrator supplies the forms; follow its instructions and your DOT agency's rules.
What is the Federal Custody and Control Form?
Part 40 requires the CCF for "every collection required by the DOT drug testing program" and forbids a non-federal or expired form (49 CFR 40.40). It is the same form HHS uses for federal agency testing; SAMHSA describes it as documenting the collection and chain of custody at the collection site, the laboratory's chain of custody and results, and the MRO's verified result, and notes that most paper CCFs are five-part carbonless forms (90 FR 42976, September 5, 2025). It may be paper or electronic: preprinted, printed on demand at the collection site, or a fully digital ECCF (SAMHSA guidance, April 29, 2026).
| Copy | Who gets it | When | Source |
|---|---|---|---|
| Copy 1 (test facility copy) | The laboratory, sealed in the specimen bag | Shipped with the specimen within 24 hours or the next business day | 40.79(a)(5) and (c) |
| Copy 2 (MRO copy) | The Medical Review Officer; carries the donor's certification and the MRO's verification | Within 24 hours or the next business day | 40.79(a)(1) and (9) |
| Copy 3 (collector copy) | The collector keeps it | At least 30 days, unless the DOT agency rule says otherwise | 40.79(a)(9) |
| Copy 4 (employer copy) | The designated employer representative (DER) | Within 24 hours or the next business day | 40.79(a)(9) |
| Copy 5 (donor copy) | The employee or applicant | At the end of the collection | 40.79(a)(4) |
If a paper form uses colored stripes on Copies 2 to 5, SAMHSA's guidance fixes the colors: MRO copy pink, collector copy yellow, employer copy blue and donor copy green.
Which version of the CCF is current?
The 2026 Federal CCF. SAMHSA's guidance dated April 29, 2026 says OMB approved its use as of April 27, 2026, and that the 2020 and 2023 forms (which are the same) may still be used: laboratories "may accept the 2020/2023 CCF without requiring a memorandum for the record (MFR) from the collector until May 31, 2027," after which the test facility must treat their use as a correctable discrepancy. SAMHSA's September 2025 notice described the planned change as a revised Step 5 on Copies 2 to 5: a shorter email line, a single "Phone No." field instead of daytime and evening numbers, and the date of birth moved. DOT announced the form on its ODAPC notice page. The print proof and completion instructions are on SAMHSA's forms page.
In Part 40, using a non-federal or expired form for a DOT test is a correctable flaw: the collector fixes it with a signed memorandum, on the same business day, stating the wrong form was used inadvertently and contained all the needed information, provided an HHS-certified laboratory tested the specimen under Part 40 (40.203(d)(3) and 40.205(b)(2)). Ask your laboratory to stop supplying old stock; suppliers may not hand out expired forms (40.40(b)).
What does the employer fill in?
Step 1, before the collection. 49 CFR 40.14 lists what the employer (or its consortium or third-party administrator) must make sure the collector has:
| Information | Notes | Source |
|---|---|---|
| Employer name, address, phone and fax | Step 1-A; may be preprinted. A third-party administrator's address may replace yours, but your name and phone must stay | 40.14(d); 40.40(c)(2) |
| DER name and contact information | Required on the form | 40.14(e); 40.40(c)(2) |
| MRO name, address, phone and fax | Step 1-B; must be the physician's name and address, not just a clinic or company | 40.14(f); 40.40(c)(2) |
| Laboratory name and address | Usually preprinted at the top | 40.14(c) |
| DOT agency that regulates the job | Step 1-D; the employer may preprint the box | 40.14(g); 40.40(c)(3); 40.72(d)(2) |
| Reason for the test | Pre-employment, random, reasonable suspicion or cause, post-accident, return-to-duty or follow-up | 40.14(h) |
| Observed or not | Direct observation applies only in the situations Part 40 lists | 40.14(i); 40.67 |
| Specimen type | Urine or oral fluid | 40.14(k) |
| Employee's full name and SSN or employee ID number | For FMCSA drivers, the "ID number" means the CDL number and state of issuance | 40.14(a) and (b); 40.3 |
Three limits: you may add billing or other needed information only outside the form's border (40.40(c)(1)); the copy that goes to the laboratory may carry no personal identifier other than the SSN or employee ID (40.40(d)); and you may not add a consent, release or waiver for the employee to sign for any part of a DOT test (40.27). Recruiters booking tests should check the candidate's phone number before it goes on the form: the MRO uses the CCF's phone numbers to reach the candidate about a non-negative result (40.131(c)).
What do the collector, donor, laboratory and MRO fill in?
SAMHSA's 2026 instructions for urine collections set the order:
- Before Step 2: the collector marks the specimen type, checks the laboratory name and that the specimen ID on the form matches the labels, and confirms Step 1 is complete, noting in Step 2 if the donor refuses to give an ID number.
- Step 2 (collector): split or single collection, observed or not, the temperature within four minutes, the volume, and any remarks about unusual behavior or the specimen.
- Step 3 (collector and donor): the collector pours and seals the bottles in front of the donor, dates the seals, and the donor initials them.
- Step 5 (donor): on Copy 2, the certification with signature, printed name, date, date of birth, phone number and email address. A donor who refuses to sign is noted in the remarks and the collection still goes ahead (40.79(a)(1)).
- Step 4 (collector): the chain of custody on Copy 1: signature, printed name, date and time of collection and the delivery service, then the specimen is bagged and shipped.
- Laboratory and MRO: the laboratory records receipt and results on Copy 1, and the MRO records the verified result in Step 6 on Copy 2 (40.127 and 40.129). How the MRO decides is in Medical Review Officer for employers.
Which CCF mistakes cancel a test?
| Problem | Effect | Source |
|---|---|---|
| No CCF; no specimen with the CCF; two collections on one CCF; specimen ID numbers that do not match; a broken or tampered seal (unless the split can be used) | Fatal flaw: the test is always cancelled | 40.199(b) |
| No printed collector name and no collector signature | Fatal flaw | 40.199(b)(3) |
| Collector's signature missing from the certification | Correctable; the laboratory tries to fix it | 40.203(b) |
| Donor's signature missing, unless the refusal to sign is noted in the remarks | Correctable by the collector's signed statement | 40.203(d)(1); 40.205(b)(1) |
| Non-federal or expired form used for a DOT test | Correctable by memorandum for the record | 40.203(d)(3); 40.205(b)(2) |
A cancelled pre-employment test means a new collection, which delays the start date. Corrections must be supplied on the same business day the problem is reported (40.205(b)).
What chain of custody form do non-DOT tests use?
Not the federal one. Under 40.13(g), an employer "must not use the CCF or the ATF in your non-DOT drug and alcohol testing programs," including a federal form with the DOT references crossed out, and a DOT test and a company test need separate specimens (40.13(b)). Company tests use the laboratory's own non-federal custody form; Quest's drug testing summary, for example, shows a custody and control form completed for its lab-based urine, oral fluid and hair tests (Quest at-a-glance sheet, 2020). Some states set the chain-of-custody standard for company tests:
| State | Chain of custody rule | Source |
|---|---|---|
| Minnesota | The employer must set chain-of-custody procedures: possession traceable to the person from collection to the laboratory; the sample always in an authorized person's possession or view or in a secured area; a written chain-of-custody record; and each transfer timed, signed and dated | Minn. Stat. 181.953, subd. 5 |
| Vermont | The collector must use a chain-of-custody procedure for collection and testing that keeps the person anonymous and verifies the identity of each sample and result | 21 V.S.A. 514(5) |
| Montana | Samples not covered by Part 40 need chain-of-custody procedures at least as stringent as Part 40; urine collection, transport and confirmation follow Part 40 | MCA 39-2-207(1) and (4) |
Other states' procedures are on the state pages under drug testing laws in hiring. A non-DOT program may also use its own consent form, which DOT tests may not (40.27); put the consent and notice wording in your drug testing policy.
Checklist for ordering a test
- DOT job: use the current Federal CCF; non-DOT job: the laboratory's non-federal form. Never mix them.
- Preprint Step 1 with your employer, DER and MRO details (the physician's name, not a clinic).
- Mark the DOT agency, "pre-employment" and the specimen type; confirm whether the collection is observed.
- Check the candidate's legal name, ID number (CDL number and state for FMCSA drivers) and phone number.
- Do not add consent or release forms to a DOT test.
- File Copy 4 with drug testing records, apart from interview notes and personnel files; retention periods are on DOT drug testing requirements.
- Staffing agencies: agree with the client whose name and DER go in Step 1; see drug testing for staffing agencies.
Questions people ask
Who fills out the chain of custody form for a drug test?
The employer supplies the Step 1 information (employer, Medical Review Officer, DOT agency, reason for the test, whether it is observed, specimen type, and the employee's name and ID number), often preprinted. The collector completes the collection and chain of custody steps, the donor signs the certification, the laboratory records receipt and results, and the MRO records the verified result.
Can I use the federal CCF for a non-DOT drug test?
No. 49 CFR 40.13(g) bars employers from using the Federal Custody and Control Form in non-DOT testing programs, even with the DOT references crossed out. Company tests use the laboratory's non-federal custody form, and some states, such as Minnesota, Vermont and Montana, set chain-of-custody requirements for them.
Is the 2023 drug testing custody and control form still valid?
It can still be used for now. SAMHSA's April 29, 2026 guidance says the 2026 Federal CCF was approved as of April 27, 2026, and that laboratories may accept the 2020 and 2023 forms without a memorandum for the record until May 31, 2027, after which their use is a correctable discrepancy.
Which copy of the CCF does the employer get?
Copy 4. Under 49 CFR 40.79, the collector sends Copy 2 to the Medical Review Officer and Copy 4 to the designated employer representative within 24 hours or the next business day, keeps Copy 3, gives Copy 5 to the employee and sends Copy 1 with the specimen to the laboratory.