Consent and compliance

The DOT SAP and return-to-duty process: the steps, the Clearinghouse and what to check before hiring a driver with a violation (2026)

On this page
  1. Which violations trigger the SAP process?
  2. What are the steps of the return-to-duty process?
  3. How does the FMCSA Clearinghouse track the process for CDL drivers?
  4. What must you check before hiring a driver who had a violation?
  5. What may employers not do during the process?
  6. What did DOT warn about in its March 2026 notice?
  7. What should staffing agencies do?
  8. How long are SAP records kept?
  9. Questions people ask

After a DOT drug and alcohol violation (a verified positive drug test, an alcohol result of 0.04 or higher, a refusal, or another violation), the employee may not perform safety-sensitive work for any DOT employer until completing the return-to-duty process in 49 CFR Part 40, subpart O: an evaluation by a Substance Abuse Professional (SAP), the education or treatment the SAP sets, a follow-up evaluation, a negative return-to-duty test, and then at least six unannounced follow-up tests in the first 12 months back at work. An employer may hire someone with a violation, but only after confirming the process is complete, getting the follow-up testing plan and running the remaining tests, as of November 2026.

What to do on the day a candidate fails is covered in what to do when a candidate fails a pre-employment drug test; this page covers the process that follows and the hiring checks for someone who has been through it.

Not legal advice. This summarizes 49 CFR Part 40 subpart O and FMCSA's Part 382 on eCFR, DOT's March 4, 2026 notice on the SAP process, ODAPC's pages and the FMCSA Clearinghouse's own FAQs, checked as of November 2026. FAA, FRA, FTA, PHMSA and Coast Guard rules add steps; confirm with your agency or counsel.

Which violations trigger the SAP process?

Part 40 treats each of these as a DOT drug and alcohol regulation violation: a verified positive drug test, an alcohol test of 0.04 or greater, a refusal to test (including an adulterated or substituted specimen), and any other violation of an agency's alcohol or drug prohibitions (40.285). The employer removes the employee from safety-sensitive functions immediately and may not return the person until the subpart O process is complete (40.23). A pre-employment failure counts too: the SAP list duty covers "an applicant or new employee" (40.287).

What are the steps of the return-to-duty process?

  1. The employer hands over a SAP list. Names, addresses and phone numbers of qualified SAPs, free of charge (40.287). ODAPC's employee page says neither DOT nor its agencies keep a list of SAPs, so the employer or its service agent compiles it. The employer does not have to provide or pay for the evaluation or treatment (40.289).
  2. Initial SAP evaluation. A face-to-face clinical assessment, in person or remote with real-time audio and video, within the geographic limits of the SAP's credential (40.291(a), 40.281(f)). The SAP must recommend education, treatment or both for every violator and must ignore claims that the test was wrong or excuses such as hemp oil or "medical marijuana" (40.293).
  3. The SAP's first report goes to the employer. On the SAP's own letterhead, directly to the designated employer representative (DER), with the violation, the dates and format of the assessment and the recommendation (40.311(c)).
  4. Education or treatment. Anything from verifiable self-help groups and courses to inpatient treatment. The SAP may not refer to programs in which the SAP has a financial interest, with listed exceptions (40.299).
  5. Follow-up evaluation. The same SAP re-evaluates and, if the employee has complied, sends a report of successful compliance with a written follow-up testing plan and any continuing-care recommendations (40.301, 40.311(d)). If not, the employer must not return the employee to safety-sensitive duty.
  6. Return-to-duty test, if the employer wants the employee back. Only after the SAP's compliance report; the drug test must be negative and the alcohol test below 0.02 (40.305(a)), and a return-to-duty drug test is a directly observed collection (40.67(b)). Putting the person back to work is still the employer's decision (40.305(b)).
  7. Follow-up testing. The SAP sets the number and frequency, at least six unannounced tests in the first 12 months of safety-sensitive duty, and may extend testing up to 48 more months; the employer picks the dates (40.307). Follow-up tests are also directly observed (40.67(b)).
StepWho does itRule
Remove from safety-sensitive workEmployer40.23
Provide the SAP listEmployer or its service agent40.287
Initial evaluation and recommendationSAP40.291, 40.293
Education or treatmentEmployee, with the provider the SAP refers to40.293, 40.299
Follow-up evaluation and testing planSame SAP40.301, 40.307
Return-to-duty testEmployer (decides whether to proceed)40.305
Follow-up tests and recordsEmployer, including later employers40.309, 40.311(h)

How does the FMCSA Clearinghouse track the process for CDL drivers?

  • The driver designates a SAP in the Clearinghouse. The SAP reports the date of the initial assessment by the close of the next business day, and the date the driver became eligible for return-to-duty testing by the close of the business day after that determination (382.705(d)).
  • The employer reports the negative return-to-duty result by the close of the third business day (382.705(b)). The Clearinghouse's return-to-duty FAQs say that report changes the driver's status from "prohibited" to "not prohibited."
  • A driver with no employer may register as an owner-operator and designate a consortium or third-party administrator only to complete the return-to-duty test; the SAP's follow-up plan is then administered by the employer the driver goes to work for, according to the same FAQs.
  • The employer reports completion of the follow-up plan (382.705(b)(1)(v)). Violations stay in the record for five years from the violation determination or until the return-to-duty process and follow-up plan are complete, whichever is later.
  • Licenses. Since November 18, 2024, state licensing agencies must remove commercial driving privileges from drivers in prohibited status (the Clearinghouse II rule, 86 FR 55718); a downgraded driver may not drive a CMV until the state reinstates the privilege (382.503(b)).

What must you check before hiring a driver who had a violation?

  1. Ask and look back two years. With the applicant's written consent, request violation and return-to-duty information from DOT-regulated employers of the past two years, and ask the applicant whether they failed or refused a DOT pre-employment test elsewhere in that time (40.25(b) and (j)). For CDL drivers the Clearinghouse full query covers FMCSA employers.
  2. Require proof the process is complete. If you learn of a violation, you may not use the person in safety-sensitive work unless you also obtain information that the return-to-duty requirements were met (40.25(e)).
  3. Get the follow-up testing plan. It is not in the Clearinghouse; request it from the previous employer (382.413(b)). The SAP must also provide reports to a gaining DOT employer (40.311(f)), and DOT's March 2026 notice says nothing in Part 40 limits how many times a SAP may send the plan to a potential or gaining employer.
  4. Run the pre-employment test. A completed return-to-duty test elsewhere does not replace your own verified negative pre-employment test (382.301).
  5. Finish the follow-up tests. The plan "follows the employee": if two of six tests were done with a previous employer, the new employer must complete the remaining four in the rest of the period (40.307(e), example 1).
  6. Aviation hires. An employee who needs an FAA airman medical certificate may not resume a safety-sensitive duty after a violation until the Federal Air Surgeon issues one dated after the violation (14 CFR 120.113(d)); see FAA drug and alcohol testing.

What may employers not do during the process?

  • Seek or rely on a second SAP's evaluation (40.295) or change the SAP's recommendations in any way (40.297).
  • Add company-authority tests beyond the SAP's follow-up plan (40.307(d)(4)), or tell the employee how many follow-up tests there will be or when (40.307(g)).
  • Count random tests or cancelled tests as follow-up tests (40.309(c) and (d)).
  • Skip the return-to-duty test, which the employer itself must arrange after the SAP's compliance report (40.305(a)). The reverse also holds: the employer is never obliged to return the person to work just because the steps are done (40.305(b)).

What did DOT warn about in its March 2026 notice?

On March 4, 2026 DOT published a notice reminding SAPs and employers of the rules (91 FR 10518). It listed problems the department had learned of: employers struggling to get follow-up testing plans from SAPs, SAPs referring employees only to online programs, SAPs prescribing the minimum number of follow-up tests under pressure from consortia, SAPs administering follow-up tests themselves, people acting as SAPs without a qualifying credential, very short return-to-duty timeframes, and remote evaluations outside the SAP's geographic limits or without real-time two-way audio and video. In practice, employers can ask a SAP for documentation that it meets the qualification rules (40.281(e)), accept reports only directly from the SAP on the SAP's letterhead (40.311(a) and (b)), and check that the report states whether the assessment was face-to-face or remote.

What should staffing agencies do?

The agency that acts as the DOT employer owns the SAP list, the return-to-duty decision and the follow-up tests, including after a layoff and recall: Part 40's own example has the employer complete the remaining follow-up tests when it recalls a laid-off employee (40.307(e), example 2). If the client runs the DOT program, put in the contract who receives SAP reports, who schedules follow-up tests and who reports to the Clearinghouse; see drug testing for staffing agencies. Recruiters screening drivers can use the truck driver screening questions, but questions about a past violation belong in the DOT inquiry process above, handled confidentially by whoever runs the testing program.

How long are SAP records kept?

Employers keep SAP reports for five years from receipt (40.311(h)), and verified positives, refusals, follow-up tests and follow-up schedules for five years as well (40.333). FAA employers also forward SAP reports about airman medical certificate holders to the Federal Air Surgeon within two working days (14 CFR 120.113(d)(3)). Related: DOT alcohol testing and refusals.

Questions people ask

How long does the DOT return-to-duty process take?

There is no fixed length. The Substance Abuse Professional sets education or treatment after an individual evaluation, and DOT has told SAPs not to give employees estimated timelines before that evaluation. After the return-to-duty test, follow-up testing lasts at least 12 months, with at least six unannounced tests, and can run up to 60 months (49 CFR 40.307), as of November 2026.

Can I hire a CDL driver who shows as prohibited in the Clearinghouse?

You may decide to hire, but you may not let the driver perform any safety-sensitive function until the return-to-duty process is complete and the negative return-to-duty result is reported, which changes the Clearinghouse status to not prohibited. A prospective employer may send the driver for the return-to-duty test once the SAP reports eligibility, and must then carry out the SAP's follow-up testing plan.

Who pays for the Substance Abuse Professional evaluation?

Part 40 leaves it to the employer and employee to decide, and it may be governed by labor agreements and health benefits (49 CFR 40.289(c)). The employer is not required to provide or pay for SAP services, but it must give the employee, including an applicant, a list of qualified SAPs at no charge (40.287).

Does a driver's follow-up testing plan transfer to a new employer?

Yes. Under 49 CFR 40.307(e) the SAP's follow-up testing plan follows the employee to later employers and through breaks in service. The plan is not in the FMCSA Clearinghouse, so a new employer must get it from the previous employer (49 CFR 382.413(b)), and the SAP may also send it directly to a gaining employer (40.311(f)).

Can a driver get a second SAP evaluation if they disagree with the first?

No. An employee who has been evaluated by a qualified SAP must not seek a second evaluation to get another recommendation, and an employer may not rely on one (49 CFR 40.295). Only the SAP who made the initial evaluation may modify it, based on new information such as reports from the treatment program (40.297).